Stringent emission targets set by the EU and other Governmental bodies have forced vehicle manufactures to develop new methods of improving the emissions of a vehicle. One such development is the EGR (Exhaust Gas Recirculation) system. Unfortunately, the manufacturers were forced to take a compromise. This was to fit an EGR valve to reduce the emissions of the vehicle, but compromise on the efficiency and reliability of the engine.

The consumer is now becoming wise to the negatives of the EGR system, becoming tired of the expensive repair bills and reliability issues they cause. Therefore, we offer a full EGR bypass / removal service which results in better efficiency and less maintenance costs. Our EGR removal service boast's the following:

§  More Power 

§  Better Fuel Efficiency

§  Improved Throttle Response

§  Less Flat Spots

§  Cleaner Intake System and Engine

§  Reduced Maintenance Costs 

§  Prolonged Engine and Turbo Life

Contact us now with your full vehicle details or reg number for a free quotation.

Read on for further technical information:

The Truth Behind EGR Valves 

Why are EGR Valves fitted?

EGR valves are fitted by manufacturers in order to reduce the amount of NOx (Nitrogen Oxide) emitted by the vehicle. However, there are more negative effects than the so say “Benefits”. 

Negative Implications:

• Reduces Efficiency 
• Reduces Performance 
• Increases Particulate Matter (Soot) 
• Causes Carbon Build up Inside The Inlet Manifold, Engine Internals and Turbo

Failure often occurs when the dirty exhaust gasses clog up the valve causing it to stick in the open position, when this happens the engine is starved of oxygen and becomes sluggish and inefficient, in some cases the vehicle can become almost un-driveable. The valves can also fail electronically when the internal motor or position sensors fail.

Removing/Deleting the EGR Valve will result in the following; 

• More Power 
• Better Fuel Efficiency 
• Less Flat Spots 
• Improved Throttle Response 
• Less Maintenance Costs 
• Cleaner Intake System 

There are two aspects to EGR Removal:

1. The EGR Valve is blanked preventing any exhaust gasses from passing through the valve and entering the intake system. EGR blanking is only required when the valves cannot fully close due to carbon build up.

2. The ECU is Remapped (Reprogrammed) and the EGR functions are removed from the ECU software or the valve is electronically programmed to remain closed at all times. This is the most important aspect of the job and it is vital that it’s done correctly. We can also remap the vehicle for better performance and fuel efficiency at the same time.